Technician Class
Entry-level amateur radio license exam covering basic regulations, operating practices, and electronics fundamentals. 35 questions, 26 needed to pass.
Which of the following is an appropriate power supply rating for a typical 50-watt output mobile FM transceiver?
Which of the following should be considered when selecting an accessory SWR meter?
Why are short, heavy-gauge wires used for a transceiver’s DC power connection?
How are the audio input and output of a transceiver connected in a station configured to operate using FT8?
Where should an RF power meter be installed?
What signals are used in a computer-radio interface for digital mode operation?
Which of the following is one of the connections required between a computer and a transceiver to operate digital modes?
Which of the following conductors is preferred for bonding at RF?
How can you determine the length of time that equipment can be powered from a battery?
What function does a digital mode hotspot perform for nearby transceivers?
Where should the negative power return of a mobile transceiver be connected in a vehicle?
What is an electronic keyer?
What is the effect of excessive microphone gain on SSB transmissions?
Which of the following can be used to enter a transceiver’s operating frequency?
How is squelch adjusted so that a weak FM signal can be heard?
What does an FM signal sound like when received slightly off frequency?
What does the scanning function of an FM transceiver do?
Which of the following controls could be used if the voice pitch of a single-sideband signal returning to your CQ call seems too high or low?
What is a DMR “code plug”?
What is the advantage of having a choice of receiver filter bandwidths in a multimode transceiver?
HAM Test Bank Editorial Team
Licensed Amateur Radio Operators & Volunteer Examiners
Content for Technician Class exam questions is based on official FCC Part 97 regulations and the NCVEC question pool.